Citrix Systems 9.3 Benutzerhandbuch

The following components are visible on the back panel of the MPX 7500/9500:

w

Four-gigabyte removable CompactFlash card that is used to store the NetScaler
software.

w

Power switch, which turns off power to the MPX 7500/9500, just as if you were to
unplug the power supply. Press the switch for five seconds to turn off the power.

w

Removable hard-disk drive (HDD) that is used to store user data. Appliances shipped
before February, 2012 store user data on a HDD. In appliances shipped after
February, 2012, a solid-state drive replaces the HDD. Both types of drive have the
same functionality and support the same software releases.

w

USB port (reserved for a future release).

w

Non-maskable interrupt (NMI) button that is used at the request of Technical
Support and produces a core dump on the appliance. You must use a pen, pencil, or
other pointed object to press this red button, which is recessed to prevent
unintentional activation.

w

Disable alarm button. This button is functional only when the appliance has two
power supplies.
Press this button to stop the power alarm from sounding when you have plugged the
MPX 7500/9500 into only one power outlet or when one power supply is
malfunctioning and you want to continue operating the MPX 7500/9500 until it is
repaired.

The Citrix NetScaler models MPX 8200, MPX 8400, MPX 8600, and MPX 8800 are 1U
appliances. Each model has one quad-core processor and 32 gigabytes (GB) of memory.
The MPX 8200/8400/8600/8800 appliances are available in two port configurations:

w

Six 10/100/1000Base-T copper Ethernet ports and six 1G SFP ports
(6x10/100/1000Base-T copper Ethernet ports + 6x1G SFP)

w

Six 10/100/1000Base-T copper Ethernet ports and two 10G SFP+ ports
(6x10/100/1000Base-T copper Ethernet ports + 2x10G SFP+)

The following figure shows the front panel of the MPX 8200/8400/8600/8800
(6x10/100/1000Base-T copper Ethernet ports + 6x1G SFP) appliance.

Citrix NetScaler Hardware Installation and Setup Guide

45