Delta 36-5052 Benutzerhandbuch

13

Table

Gauge

Rail

Table

Gauge

Rail

1.  Attach the front rail (A) (2” X 2” X 57” for 

the 30” rip capacity models), (2” X 2” X 

79” for the 52” rip capacity models), to 

the saw table and extension wings using 

5/16-18 x 1 1/8inch flat head screws.  

Align the holes in the rail with the holes 

in the table and extension wings.

2.  Use supplied rail alignment gage (B) to 

ensure the rail is the proper distance 

from the top of the table at each side of 

the cast iron table. (fig 6)  Then use the 

alignment  gage to set the same proper 

distance for the extension wings.

3.  Align the rear rail to the holes in the 

rear of the saw table and extension 

wings.  Attach the rear rail to the saw 

table using two 5/16-18 x 7/8 Hex head 

screws.

4.  Attach the rear rail to the extension 

wings using 5/16-18 X 7/8 inch hex head 

screws and Hex flange nuts. 

5.  Use supplied rail alignment gage (B) to 

ensure the rail is the proper distance 

from the top of the table at each side of 

the cast iron table. (fig 6)  Then use the 

alignment  gage to set the same proper 

distance for the extension wings.

1.  Attach the left and right side extension 

wings (A) to the table using three 5/16-

18 x 7/8” hex head screws for each 

wing.  

2.  Make sure the top edges of the wings 

are flush with the top of the table and 

tighten all six screws.

3.  Proceed to rail assembly.

0

1

2

3

4

5

6

7

8

9

10

11

12