Delta 36-5052 Benutzerhandbuch

14

1.  Connect the fence guide tube (A) by inserting the smaller 

end into the larger end. See Figure 10

2.  Attach the fence guide to the front rail using four (for 

30" versions) six (for 52" versions) 1/4-20 x 1/2-inch hex 

button head screws and ¼-inch spring washers 

through the holes (B) on the bottom side of 

the front rail. 

3.  Align the two holes in the power 

control box bracket with the holes 

underneath the front rail (C), located 

on the left side of the saw. Secure 

the power control box to the front rail 

using two1/4-20 x 1/2-inch button 

head screws. 

4.  Fix the hanging power cord at rear side of 

front rail by wire clip and M5 x 6mm round 

head cross screw.

1.  Lay the wood table (A) upside down on floor or 

bench.

2.  Position legs (B) in corner as shown (fig 7) the 

vertical wall of the angle plate on the leg should 

be against the end wood wall (C) of the table.

3.  Fasten the legs to the table board with (8) #8 x 

5/8”  self-tapping screws (D).

4.  Carefully drill through the holes in the vertical 

angle plate holes and the wood wall of the table 

with a ¼ inch drill.  Feed the #10 by 1 ¾” screws 

(E) through the drilled holes from the outside, 

then assemble the #10 washers and nuts onto 

the screws and tighten.

5.  Loosely assemble (3) 5/16-18 x 7/8 inch screws, 

washers and nuts (F) into the three holes in the 

side of the extension wing as shown.  (fig 8)

6.  Carefully lower the slotted steel angle table 

bracket (G) down onto the screws on the 

extension wing.  Tighten the screws after the 

wood table is leveled with the extension wing.

7.  Using the rail alignment gauge (H) adjust the 

feet in the legs (I) so the top of the table is at the 

proper distance from the rail.

8.  Drill ¼ inch holes through the rail holes (J) into 

the wood table on the front and back rails. (fig 9)

9.  Fasten wood table to rails with ¼-20 X 1 ½ inch 

screws, flat washers, lock washers, and nuts.