Southbend SB1013 Benutzerhandbuch

-70-

For Machines Mfg. Since 7/09

EVS Toolroom Lathes

  Remove pedal stop shown in Figure 139.

  Move the brake band to the right one hole, 

and re-install the pedal stop, tightening it 
until it is just snug.

— If installing a new brake band, install the 

cap screw so there is one hole to the left 
for future brake adjustment.

 

Firmly push the pedal lever (Figure 140) to 
the right until it stops and the brake band is 
fully clamped around the brake hub.

  Tap the pedal stop into position so there 

is approximately a 25mm gap between the 
pedal lever and the stop (see Figure 140).

  Tighten the cap screw on the pedal stop.

  Locate the motor kill switch (shown in 

Figure 141) at the tailstock end of the lathe.

  Push the pedal lever down to verify that the 

cam lobe pushes the kill switch plunger in. 
When pushed in, the switch should click.

— If the switch does not click, loosen the 

switch mounting screws, push the pedal 
all the way down, and move the switch 
closer to the lobe until it clicks. Secure the 
switch in place at this location.

— In the released position, there should be 

an approximate 3mm gap between the 
plunger roller and the lobe.

  Re-install the cover, test the brake operation.