Southbend sb1016 Benutzerhandbuch

-28-

For Machines Mfg. Since 7/09

Model SB1016/SB1036

  Lift the chuck guard shown in Figure 28, 

and try to start the lathe again. The cover 
kill switch should prevent the lathe from 
starting while the guard is open.

  Close the chuck guard.

  Open the cutting fluid valve, and using the 

pump switch shown in Figure 28, turn the 
cutting fluid pump ON. Verify that fluid 
flows from the nozzle, then turn the cutting 
fluid pump OFF. 

— If no fluid is pumped, but fluid level is 

full, no hose kinks exist, and the cutting 
fluid nozzle is open, the pump may be 
wired with incorrect phase polarity. 
Correct the pump phase polarity wiring as 
outlined on Page 16.

The test run is now finished. Shut the lathe down 
and begin the Spindle Break-In procedure.

It is essential to closely follow the proper break-in 
procedures to ensure trouble-free performance. 
Complete this process once you have familiarized 
yourself with all instructions in this manual and 
completed the test run.

  Make sure you have completed the Test 

Run procedure beginning on Page 25.

  Turn the spindle speed dial (Figure 29) all 

the way counterclockwise to the minimum 
speed.

  Move the spindle range lever (Figure 30) to 

low speed range 1 (18-55 RPM). 

 You may need to slightly rotate the chuck 

by hand to engage the lever.