Southbend sb1016 Benutzerhandbuch

For Machines Mfg. Since 7/09

Model SB1016/SB1036

-45-

  Use calipers to measure both ends of the 

workpiece.

— If the machined workpiece is thicker 

at the tailstock end, move the tailstock 
toward the operator 

1

⁄

2

 the distance of the 

amount of taper (see Figure 70).

 Repeat Steps 7–9 until the desired accuracy 

is achieved.

Move the tailstock toward 

the operator half the 

distance of the taper.

Looking down from above.

— If the machined workpiece is thinner at 

the tailstock end, move the tailstock away 
from the operator 

1

⁄

2

 the distance of the 

amount of taper (see Figure 71).

Move tailstock away from 

the operator half the 

distance of the taper.

Looking down from above.