Southbend SB1027 Benutzerhandbuch

For Machines Mfg. Since 8/09

Model SB1027

-47-

4.  Remove the brass bevel gear from the 

leadscrew, then remove the leadscrew 

alignment key (see Figure 54).

5.  Brush a light coat of lubricant on the teeth 

of the bevel gear and the smaller drive gear 

(see Figure 55).

6.  Replace the leadscrew alignment key, then 

align the bevel gear keyway with the key as 

you slide the gear onto the leadscrew and 

mesh its teeth with the drive gear.

7.  Replace the graduated dial ring into position 

and secure it with the knurled retaining 

ring—do not overtighten.

8.  Slide the ball handle onto the leadscrew, 

align the keyway with the leadscrew 

alignment key, then secure it with the hex 

nut removed in Step 2.

9.  Move the table with the power feed ball 

handle to check the gear movement and to 

distribute the grease on the gears. If the 

movement is not smooth, repeat Steps 2–8 

until it is.