Bad Boy Mowers 02.9812.0001C Benutzerhandbuch

The Comm LED - located on the upper enclosure connector 
panel - indicates system control status. This can be used 
determine if the luminaire is receiving a control signal. LED 
indications are as follows:
•

Green - The Comm LED will light green if either DMX 
or Ethernet control is present. Note that if both valid 
DMX and Ethernet control are being received, DMX 
control will take precedence.

•

Red - The Comm LED will light red if no DMX or 
Ethernet is present.

If the menu screen is touched (in the center) and held during startup, the 
luminaire will present a menu that provides the option to bypass 
calibration. This feature allows the luminaire to skip the calibration 
sequence so that it can be powered up in the case for configuration 
purposes.
To bypass calibration:
Step 1. Connect power to luminaire.
Step 2. At startup, touch center of menu screen and hold until Bypass 

Calibration menu appears.

Step 3. Press Yes to bypass calibration. (The menu will 

automatically dismiss if no selection is made within 5 
seconds.)

Step 4. Proceed with programming of starting address or other options.

CONFIG

addr

043

univ

A

1400w

LAMP

hrs

125

temp

34C

INFO

01:34

TEST

COMM

DMX

STATUS

OK

Comm LED