Bad Boy Mowers 02.9812.0001C Benutzerhandbuch
I
NSTALLATION
: P
OWER
U
P
AND
B
ASIC
S
ETUP
P
ROCEDURES
0 2. 9 8 1 2. 0 0 01 C
23
2
Setting a Starting Address
The method for setting a DMX starting address is the same whether the luminaire is being controlled
by DMX512 or Ethernet (Art-Net). The only difference is that the Home screen will display the Comm
as either "DMX" or "ETH" depending on the control input.
The DMX starting address is programmed at the Menu Touchscreen. The luminaire retains its address
even if power is removed.
by DMX512 or Ethernet (Art-Net). The only difference is that the Home screen will display the Comm
as either "DMX" or "ETH" depending on the control input.
The DMX starting address is programmed at the Menu Touchscreen. The luminaire retains its address
even if power is removed.
Note: Refer to your console operating instructions for specific information regarding its addressing
requirements.
requirements.
DMX Comm
The starting address for DMX512 systems is programmed using the CONFIG menu.
To program a starting address:
Step 1. At Home screen, press CONFIG panel.
Step 2. At Configuration screen, press DMX ADDRESS panel.
Step 3. At numeric keypad, enter new starting address and press ENTER.
To program a starting address:
Step 1. At Home screen, press CONFIG panel.
Step 2. At Configuration screen, press DMX ADDRESS panel.
Step 3. At numeric keypad, enter new starting address and press ENTER.
Figure 2-13: Setting Starting Address (DMX Control)
Note: Refer to
on page 30 for more information about the Menu Touchscreen.
Control Input Type