Hotpoint DWF61 Benutzerhandbuch

WARNING
● Connect your dishwasher drain hose to
pipes which connect to the foul drain
system, and not to surface water drains.
IMPORTANT NOTES    For the correct
operation of your dishwasher, it is
essential to comply with the following
information.

Fit the hose to the standpipe
hook which can be found in
the machine.

Ensure that the hose is not
pushed too far down the
standpipe.

DO NOT position the    stand-
pipe near an electrical outlet.
ENSURE that the drain hose is
routed as shown in the diagram.

The standpipe should be connected to:
a) A discharge stack-pipe
b) An external gulley OR
c)  A sink waste.

The standpipe should have a bore of at
least 38mm (1

1

/

2

"). It should be installed as

shown, have a trap fitted and must
discharge into the same drain system as
your household sink.
It must NOT be connected to a surface
water drain.

For under sink drainage:
Before connecting the drain hose,
remove any internal restrictions - This
will prevent a build up of debris which
could cause a blockage.
Remove any restrictions from the waste
spigot and ensure that the sealing
bung is removed. The hose should be
routed, such that it is raised to a
minimum height of 800mm (3

1

/

2

")            

1. Untie the end of the GREY drainage 

hose from the rear of the appliance.

2. Reposition ‘Hooked End Support’ as 

required along GREY drainage hose.

3. If fitting an under sink waste disposal 

unit, cut out the membrane, bung or 
blanking plug.

4. Attach the GREY drainage hose to   

the under sink waste disposal unit 
securely, using the clip and rubber 
tube supplied.

5

120
min