Hotpoint DWF61 Benutzerhandbuch

● For your machine to operate correctly 

it requires water pressures in the range 
of 6-150 psi (100-1000 KPa). Most 
cold water supplies will be in this 
range.

● Ensure the fill hose is only connected 

to the cold water supply.

WARNING
● Ensure the fill hose is NOT kinked.

Note: Do not over tighten the hose  connec-
tor. Hand tight is sufficient.
● Tap connections (if applicable) - A 

range of adaptors are available to suit 
your tap.

WARNING
● Do not connect appliance to a single

When you have installed your appliance,
ensure it is ready to use by following this
Check List:
1. Dispose of packaging safely, see 

‘Recycling Information’ on page 2.

2. Position appliance close to 

electrical/water supply  see ‘Choose a 
Location’ on page 4.

3. Connect supplied hose to appliance 

water supply, confirm water is flowing 
before connecting to the appliance 
inlet valve see ‘Connect to a Water 
Supply’, page 6.

4. Untie drainage hose at rear of 

appliance and connect to either a 
standpipe or sink waste drainage   
system see ‘Connect to a Drainage 
System’ page 5.

5. Untie mains lead at rear of appliance 

and plug into electrical supply via a 
switched socket, see ‘Electrical 
Supply’ on page 3.

6. Position appliance, taking care not to 

kink or damage hose at rear of     
appliance.

7. Stabilise the appliance, see ‘Adjusting 

the Feet’ page 4.

8. Turn on the water supply to the    

appliance.

9. Switch on at plug socket.

6