GE JGP630 Benutzerhandbuch
13
Installation Instructions
MAKING THE LP CONVERSION
SAFETY INFORMATION YOU
SHOULD KNOW
SHOULD KNOW
The pressure regulator and burner orifices
are set for natural gas. To use Propane Gas,
the regulator and burner orifices must be
converted. The LP orifice spuds for the
cooktop burners can be located in the
literature package attached to the regulator.
are set for natural gas. To use Propane Gas,
the regulator and burner orifices must be
converted. The LP orifice spuds for the
cooktop burners can be located in the
literature package attached to the regulator.
CAUTION:
The cooktop, as shipped
from the factory, is set for use with natural
gas. If you wish to use your cooktop with
Liquefied Petroleum (Propane) gas, you must
first replace the orifices and convert the
pressure regulator.
gas. If you wish to use your cooktop with
Liquefied Petroleum (Propane) gas, you must
first replace the orifices and convert the
pressure regulator.
WARNING:
This conversion must
be performed by a qualified installer or gas
supplier in accordance with the manufacturer’s
instructions and all codes and requirements
of the authority having jurisdiction. Failure
to follow instructions could result in serious
injury or property damage. The qualified
agency performing this work assumes
responsibility for the conversion.
supplier in accordance with the manufacturer’s
instructions and all codes and requirements
of the authority having jurisdiction. Failure
to follow instructions could result in serious
injury or property damage. The qualified
agency performing this work assumes
responsibility for the conversion.
CAUTION:
The following adjustments
must be made before turning on the burner.
Failure to do so could result in serious injury.
Be sure pressure regulator has been
converted as described in Step 2.
Failure to do so could result in serious injury.
Be sure pressure regulator has been
converted as described in Step 2.
1
ADJUST YOUR COOKTOP FOR
USE WITH LP GAS
USE WITH LP GAS
Disconnect all electrical power, at the
main circuit breaker or fuse box.
main circuit breaker or fuse box.
Shut off the gas supply to the cooktop
by closing the manual shut-off valve.
by closing the manual shut-off valve.
Adjust the pressure regulator, by the
following instructions:
following instructions:
• Unscrew the cap.
• Place your thumb against the flat side
of the spring retainer and press down
to remove the retainer.
to remove the retainer.
• Carefully look at the spring retainer to
locate the NAT or LP position.
• Turn the spring retainer over so that
LP is showing on the bottom.
• Snap the retainer back into position.
• Screw the cap back onto the regulator.
C
B
A
2
DOWN
FOR OFF
NAT
LP
LP
NAT
LP
NAT
NAT
LP
Gasket
Cap
Spring
Retainer
Retainer
L.P./Propane
Position
Position
NAT.
Position
Pressure Regulator
TOOLS YOU WILL NEED
FOR LP CONVERSION
FOR LP CONVERSION
Safety Glasses
Small Flat-Head
Screwdriver (4mm
or 5/32
″ tip size,
60mm long)
Phillips Head
Screwdriver
Pliers
7mm Nutdriver
No. 15 Torx-Head
Driver