Jenn-Air W10197059B Benutzerhandbuch

To properly install your cooktop, you must determine the type of 
electrical connection you will be using and follow the instructions 
provided for it here.

■

A 4-wire or 3-wire, single phase, 120/240 volt, 60 Hz., AC only 
electrical supply on a separate, 40-amp circuit breaker is 
required for both 30" (76.2 cm) and 36" (91.4 cm) models. If a 
fused system is used, fuse both sides of the line. 

■

The cooktop should be connected directly to the junction box 
through the flexible metal conduit. The flexible, armored cable 
extending from the fuse box or circuit breaker box should be 
connected directly to the junction box.

■

Locate the junction box to allow as much slack as possible 
between the junction box and the cooktop so that the cooktop 
can be moved if servicing becomes necessary in the future.

■

A UL listed or CSA approved conduit connector must be 
provided at each end of the power supply cable (at the 
cooktop and at the junction box). 

■

If the house has aluminum wiring follow the procedure below:

1. Connect a section of solid copper wire to the pigtail 

leads.

2. Connect the aluminum wiring to the added section of 

copper wire using special connectors and/or tools 
designed and UL listed for joining copper to aluminum.

Follow the electrical connector manufacturer's recommended 
procedure. Aluminum/copper connection must conform with 
local codes and industry accepted wiring practices.

Decide on the final location for the cooktop.

1. Open product as instructed on product packaging.
2. Remove shipping materials and tape from cooktop.
3. Remove vent grille.

4. Remove the removable grease filter by lifting the filter out.
5. Using 2 or more people, remove the cooktop from the carton.
6. Use foam end caps from the packaging as a work surface for 

the floor or countertop.

7. Using 2 or more people, place the cooktop upside down on 

the foam end caps.

8. Make sure knobs are positioned in the open areas of the end 

caps.

9. Avoid placing the cooktop facedown on the control knobs.

1. Remove foam strip from the package containing literature. 
2. Remove backing from foam strip. 
3. Apply foam strip adhesive-side down around bottom of 

cooktop, flush with edge.
NOTE: The foam strip keeps the underside of the cooktop 
glass free from debris and helps the cooktop sit flat on uneven 
counters.  

IMPORTANT: The following additional steps must be performed if 
the product is being installed in peninsula or island cabinetry.
The blower exhaust scroll is shipped from the factory set to 
exhaust straight out the back of the cabinet through an exterior 
wall.

A

B

C

D

A

B

C

D

E

C

A

E

F

B