Viking SLCL Benutzerhandbuch

5.03

4.01

5.04

fIGURE 19

4.01

fIGURE 20

4.01

5.04

fIGURE 21

TWO TIMING

MaRKs ON dRIVE

ONE TIMING

MaRK ON laY

fIGURE 22i

fIGURE 18

5.01 / 5.02

5.12

5.03

fIGURE 22ii

NOTE: On a right hand helical gear, the form of

the teeth slants to the right.

SECTION TSM 288

ISSUE

PAGE 13 OF 36

4.1 PUMP assEMblY sla-slf
4.1.1 sHafT assEMblY

• Install a nominal 0.1 mm (0.003”) shims (5.12) and bearing

cone (5.03) onto shaft (5.01 / 5.02)

• Install shafts assemblies into the bearing housing (4.01)

• Install rear bearing cone (5.04) into the bearing housing

(4.01)

• Install bearing cups (5.03 / 5.04) into the bearing housing

(4.01)

• To set the timing marks on the gears (5.06) place the gears

next to each other and line up the keyways, you can now

punch three timing marks to show the correct alignment of

the gears see Figure 22i.

NOTE: When installing the gears onto the shaft make sure

that you use the right hand helical gear on the drive shaft (See

Figure 22ii) The right hand helical gear will have the letter ‘D’

stamped on the face.