Viking SLCL Benutzerhandbuch

SECTION TSM 288

ISSUE

A

PAGE 29 OF  36

The washers overlap the seal bore – this locates and provides 

drive to the seal.

•  Install the slinger (5.15)

NOTE: the slinger has raised sections on the internal diameter, 

which press onto the shaft
•  Install the O-rings (8.12)(8.19) and the wave spring (8.13) 

into the sleeve (8.15) and then install the housing (8.10) onto 

the sleeve, Install the assembly onto the shaft

NOTE: There are two drive slots in the shaft which must be 

lined up with the drive pins on the sleeve.

•  Install the seal washers (8.08) and the seal screws (8.09)

•  Install  the  guard  (7.03)  and  casing  (3.01)  and  secure  with 

screws (4.07) (See section 6.2 for torque settings)