Viking SLCL Benutzerhandbuch

SECTION TSM 288

ISSUE

A

PAGE 30 OF  36

•  To  remove  the  seal  face  in  the  rotor  use  the  seal  face  

removal tool

•  The tool locates on the rubber L-cup and when pressed in 

the seal face will extrude up into the tool allowing ease of the 

seal face removal (A press tool may be required)

•  Install the O-ring (8.06) into the seal housing and then install 

the seal housing (8.10)   into the casing 

•  making sure that the location recesses line up with the seal 

washers (8.08) (See Figure 47 and Figure 44)

•  Install the O-ring (8.04) onto the static seal (8.03) and then 

install the static seal into the casing – make sure that the 

location slots line up with the pins in the seal housing

•  Install  the  L-cup  (8.01)  and  the  rotary  face  (8.02)  into  the 

rotor (2.01)

The seals are now assembled.
For rotor and head installation see pump assembly section.