DeLonghi ECAM45.760 Benutzerhandbuch

15

The appliance is set by default to automatically deliver standard 
quantities. To change these quantities, proceed as follows:
1.  Place a cup under the coffee spouts and milk spout.
2.  Select the desired froth dial position for the drink type to 

be programmed.

3.  Press and hold one of the function buttons until the name 

of the hot drink and the message “PROGRAM MILK” is 
displayed. 

4.  Release the button.  The appliance starts delivering milk.
5.   Once the required quantity of milk has been delivered into 

the cup, press the button again. 

6.   The appliance stops delivering milk and, if included in the 

drink, after a few seconds the coffee is delivered into the 
cup: the name of the hot drink and “PROGRAM COFFEE” is 
displayed.

7.   Once the required quantity of coffee has been delivered 

into the cup, press the button again.  Coffee delivery stops.

The machine is now reprogrammed with the new milk and cof-
fee quantities. 

The appliance is set by default to automatically deliver standard 
quantities. 
To change these quantities, proceed as follows:
1.  Press the MILK MENU button.
2.  Press < or > until the required drink is displayed (MILK, 

CAFFELATTE, ESPRESSO MACCHIATO or MY MILK).

3.  Hold the OK button until the name of the drink and “PRO-

GRAM MILK” are displayed.

4.  Release the button.  The appliance starts delivering milk.
5.  Once the required quantity of milk has been delivered into 

the cup, press the OK button. 

6.  The appliance stops delivering milk and, if included in the 

drink, after a few seconds the coffee is delivered into the 
cup:  the name of the hot drink and “PROGRAM COFFEE” is 
displayed.

7.  Once the required quantity of coffee has been delivered 

into the cup, press the OK button again. Coffee delivery 
stops.

The machine is now reprogrammed with the new milk and cof-
fee quantities. 

Never leave the machine unsupervised while delivering hot 
water or steam. 
The spout becomes hot. Hold by the handle only. 

If “Energy saving” mode is active, you may have to wait a few 
seconds before the hot water or steam is delivered.

1.  Make sure the hot water spout is attached correctly (fig. 7).
2.  Place a container under the spout (as close as possible to 

avoid splashes). 

3.  Press the 

button (fig. 3). “HOT WATER” is displayed, 

together with a progress bar which fills gradually as pre-
paration proceeds. 

4.  The machine delivers 250 ml of hot water, then delivery 

stops automatically.  To interrupt delivery of hot water ma-
nually, press the 

button again. 

The machine is set by default to automatically deliver 250 ml 
of hot water.  
To modify these quantities, proceed as follows:
1.  Position a container under the spout.
2.  Press and hold the 

button until “Hot water Program 

quantity” is displayed, then release the 

 button.

3.  When the hot water in the cup reaches the required level, 

press the 

 button again.

The machine is now reprogrammed with the new quantity. 

1.  Make sure the hot water spout is attached correctly (fig. 7).
2.  Fill a container with the liquid to be heated/frothed and 

immerse the spout/traditional frother (D5) in the liquid.

3.  Press the 

 button: after a few seconds, steam comes 

out of the traditional frother and heats the liquid; “STEAM” 
is displayed.

4.  When the required temperature is obtained, interrupt 

steam delivery by pressing the 

button. (You should not 

discharge steam for more than 3 minutes at a time). 

Always stop steam delivery before extracting the container con-
taining the liquid to avoid burns from splashes.