Hoshizaki DT-400BAH-OS Benutzerhandbuch
11
H. Startup
CAUTION
1. All parts are factory-adjusted. Improper adjustments may result in failure.
2. If the icemaker is turned off, wait for at least 3 minutes before restarting the
2. If the icemaker is turned off, wait for at least 3 minutes before restarting the
icemaker to prevent damage to the compressor.
1) Make sure the icemaker is unplugged and the power switch on the control box is in the
"OFF" position.
2) Clean the storage bin.
3) Open the water supply line shut-off valve and check for water leaks.
4) Plug the icemaker into the electrical outlet.
5) Move the power switch on the control box to the "ON" position.
6) Move the dispense mode switch to the desired setting, "PORTION" or "CONTINUOUS."
7) Move the control switch to the "ICE" position to start the automatic icemaking process.
8) Check the bin control for correct operation. Move the actuator located on the inside of
3) Open the water supply line shut-off valve and check for water leaks.
4) Plug the icemaker into the electrical outlet.
5) Move the power switch on the control box to the "ON" position.
6) Move the dispense mode switch to the desired setting, "PORTION" or "CONTINUOUS."
7) Move the control switch to the "ICE" position to start the automatic icemaking process.
8) Check the bin control for correct operation. Move the actuator located on the inside of
the bin top panel. The compressor should stop about 90 seconds later. The gear motor
should stop about 60 seconds after the compressor stops.
should stop about 60 seconds after the compressor stops.
9) Replace the panels in their correct positions.