Hoshizaki DT-400BAH-OS Benutzerhandbuch

19

1. This icemaker must be maintained individually, referring to the instruction 

manual and labels provided with the icemaker.

2. To achieve optimum icemaker performance, the following parts need 

periodic inspection and maintenance:

     

Extruding Head and Upper Bearing

     

Housing and Lower Bearing

     

Evaporator Cylinder

     

Auger

     

Gear Motor

     

Mechanical Seal

These parts should be inspected at least once a year or every 10,000 hours 
of operation. Their service life, however, depends on water quality and 
environment. More frequent inspection and maintenance are recommended in 
bad or severe water conditions.
Replacement of the following consumable parts is recommended if wear 
exceeds factory recommendations:
     

Upper Bearing

     

Lower Bearing

     

Mechanical Seal

Consult with your local distributor about inspection and maintenance service. 
To obtain the name and phone number of your local distributor, call Hoshizaki 
Technical Support at 1-800-233-1940 in the USA.

1. Icemaker and Storage Bin 
 • Hoshizaki recommends cleaning this icemaker at least twice a year. More frequent 

cleaning, however, may be required in some existing water conditions.

 • The storage bin is for ice use only. Do not store anything else in the bin.

A plastic mesh air filter removes dirt and dust from the air and keeps the condenser from 
getting clogged. As the filter gets clogged, the icemaker's performance will be reduced. 
Check the filter at least twice a month. When clogged, use warm water and a neutral 
cleaner to wash the filter. 

Check the condenser once a year, and clean if necessary by using a brush or vacuum 
cleaner. More frequent cleaning may be required depending on the location of the 
icemaker.

To prevent corrosion, wipe the exterior occasionally with a clean, soft cloth. Use a damp 
cloth containing a neutral cleaner to wipe off oil or dirt build up.