Hoshizaki DT-400BAH-OS Benutzerhandbuch

6

1. Install in accordance with all applicable national, state, and local regulations.
2. Ensure all components, fasteners, and thumbscrews are securely in place 

after installation.

3. Remove the shipping carton, tape, and packing material. If any are left in the 

icemaker, it will not work properly.

1) Remove the panels to prevent damage when installing the icemaker. See "II.B. How to 

Remove Panels."

2) Remove the package containing the accessories.
3) Remove the protective plastic film from the panels. If the icemaker is exposed to the 

sun or to heat, remove the film after the icemaker cools. 

4) Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the 

fan blade turns freely. 

5) Check that the compressor is snug on all mounting pads.
6) See the nameplate on the rear panel, and check that your voltage supplied corresponds 

with the voltage specified on the nameplate.

• Upper Front Panel: Remove the screw. Lift up and towards you.
• Top Panel: Remove the thumbscrew. Lift up 

at front slightly, push rearward and lift off.

• Apron Panel: Remove the screws and pull 

towards you.

• Side Panel: Remove the screws. Slide 

forward slightly, and lift off.

• Lower Front Panel: Remove the screw and 

pull towards you.

Apron Panel

Side Panel

Upper Front Panel

Side Panel

Top Panel

Lower Front Panel