Broan EW5636SS Benutzerhandbuch

L

1.  Center the flue mounting bracket over the hood location and

flush  with  the  ceiling.  Secure  the  upper  flue  bracket  to  the

wall using (2) 4mm x 38mm mounting screws. Note: Drywall

anchors may be needed (not included).

2.  Tighten the screws completely. Make sure that the bracket is

tight against the wall and ceiling.

3.  Remove (3) screws holding electronics mounting bracket to

hood.  Rotate  bracket  180  degrees  and  re-attach  bracket  to

hood with same (3) screws.

4.  Remove  the  protective  plastic  film  covering  the  decorative

flue and the hood at this time.

5.  Remove the grease filter by pulling down the metal latch tab

and tilting filter downward to remove.

6.  Align the keyhole slots on the hood with the mounting screws

that were partially tightened into the wall framing. Ensure that

hood is seated entirely on mounting screws, and that hood is

level. Then tighten screws completely.

7.  Install (2) 4mm x 38mm long screws into the holes inside the

hood and tighten them securely.

8.  Carefully place glass canopy on top of the hood. Align nuts

on glass canopy with holes inside the hood. Attach canopy

with (4) .188” x .250” long flat head screws. Tighten screws

securely but DO NOT OVERTIGHTEN.

9.  Reinstall  grease  filter  by  aligning  side  filter  tab  with  slots

in  the  hood.  Pull  down  the  metal  latch  tab,  push  filter  into

position  and  release.  Make  sure  filter  is  securely  engaged

after installation.