AEG PV.500-MH Benutzerhandbuch

Seite von 68
Protect PV.500_MH Operating Instructions 
 
80000043212 BAL 
53 of 68 
Connections: 
CN1: 
Internal inverter bus and power supply 
MOD1: Ethernet 
connection 
CN5: 
Interface for firmware update 
Configuration jumpers: 
CN3:  
All closed (default) 
LED signals: 
Green LED (H1): 
The green LED on the assembly indicates the global status of the 
assembly. The following signals are possible: 
LED  Jumper 
Meaning 
Flashing CN3 
Start-up/error 
On CN3 
Ready 
Flickering CN3 Ethernet 
 CAN communication 
 
Green network LED (MOD1): 
The green LED indicates communication on the network. 
Yellow network LED (MOD1): 
The yellow LED remains on permanently if an Ethernet network is 
connected. 
7.2.4  Installation of the COM Server 
The COM server uses a communication module from Digi ("Digi 
Connect ME"). In order to communicate via the COM server, it 
must be integrated into the network and a virtual COM port must 
be set up on a computer. The "Digi Device Discovery" tool and a 
Digi RealPort driver are required for this purpose. You can find 
these tools at www.digi.com/support or at www.aegps.com. 
Network factory settings for the COM server: 
IP address: 
10.10.10.0 
Subnet mask:  
255.255.0.0 
Default gateway:  
0.0.0.0 
downloadlike
ArtboardArtboardArtboard