Multiquip QP4TH Benutzerhandbuch

1.  Place the engine fuel valve lever (See Figure 7) to the 

ON position.

2.  Move the throttle lever (See Figure 8) away from the 

slow position, about 1/3 of the way toward the fast  

position.

3.  Place the choke lever (See Figure 9) in the 

position if starting a cold engine. 

DO NOT attempt to start the engine unless the pump 

has previously been primed with water. Severe pump 

damage will occur if pump has not been primed.

4.  Place the

 choke lever (See Figure 10) in the OPEN 

position if starting a warm engine or the temperature 

is warm.

5.  Place the engine 

ON/OFF switch (See Figure 11) in 

the 

ON position.

6.  Grasp the starter grip (See Figure 12) and slowly pull 

it out. The resistance becomes the hardest at a certain 

position, corresponding to the compression point. Pull 

the starter grip briskly and smoothly for starting.

7.  If the engine has started and the choke lever was 

moved to the 

CLOSED position to start the engine, 

gradually move the choke lever to the 

OPEN  position  

(Figure 13) as the engine warms up. If the engine has 

not started repeat steps 1 through 6.