DCS 30 inch Benutzerhandbuch

Seite von 31
Turn on the ventilator hood 
above the range and leave it on 
until after the oven has completed 
the self-clean cycle.
1) Push the “CLEAN” Selector Button.
2) Set Thermostat to “CLEAN”.
 Cooling Blower turns on,
OVEN ON light and HEATING 
light turn on,
LOCK light turns on,
 
  The door closing process takes approximate-
ly 60 seconds to complete, at which time the door
becomes locked.
The Clean cycle takes 4 to 5 hours to complete.  The
blower and the OVEN ON light turn off once the
cycle has finished.
1) Push the OFF Selector Button.
The door latch will open automatically after the
oven temperature falls below 550ºF and the auto-
matic Door Lock completes its 60 sec. cycle to the
OPEN position.
2) Turn the Thermostat to OFF 
3) Replace the oven rack slide assemblies by A)
Guiding the rear of the rack slide assembly into the
bottom rear bracket of the oven side, B) Guide the
top rear of the rack slide assembly into the top U-
shaped bracket of the oven side, C) Lift up the Push
Rod so that it rests on the “ledge” of the side sup-
port of the assembly, and D)  Screw the assembly
secure to the oven through the hole in the front
middle section of the side support.  Repeat for the
other side of the oven.  
(SEE ILLUSTRATION BELOW)
CAUTION:
The interior of the oven will still
be at baking temperatures when the lock light turns off and
the oven door can be opened.  Use caution as the Oven may
be hot enough to cause burns.
AT THE END OF THE CLEAN CYCLE:
OFF
BAKE
CONV.
BAKE
BROIL
OVEN ON
CLEAN
HEATING
DOOR LOCKED
SETTING THE 27”&24”OVEN FOR SELF-CLEANING:
23
27” & 24” OVEN SELF-CLEANING