Omron 3G3FV-PDRT1-SIN Benutzerhandbuch

This section describes examples of simple operation programming using special remote I/O. To use
special remote I/O, it is necessary to switch the remote I/O operation. Refer to 5-3 Switching Remote I/O
Operation and change to the special remote I/O operation.

Once the Program Start Input Bit is turned ON, Inverter operations will continue until the Program End
Input is turned ON. The frequency (speed) reference specified in the DM Area (DM1000) of the PC is
repeatedly set in the Inverter. The output frequency value will be repeatedly read and stored in the DM
Area (DM 2000). The Inverter status will also be read repeatedly and stored in words (020**) allocated in
the PC.

If any communications error occurs, the program will stop and a stop command will be sent to the Invert-
er. This state will continue until the Communications Fault Reset Input Bit is turned ON.

Note Write the program so that the Inverter operation commands (01000 and 01001) will be turned

OFF when the Fault Bit (02007) of the Inverter status turns ON, and also take appropriate coun-
termeasures according to maintenance information in the SYSDRIVE 3G3FV High-function Gen-
eral-purpose Inverter User’s Manual.

H

D

01000

Forward/Stop (1: Forward) Bit

01001

Reverse/Stop (1: Reverse) Bit

01002

Multi-function Input 1 Bit

01003

Fault Reset Input Bit
(Multi-function Input 2 Bit: Initial setting)

01004

Multi-function Input 3 Bit

01005

Multi-function Input 4 Bit

01006

Multi-function Input 5 Bit

01007

Multi-function Input 6 Bit

D

02000

During Run Bit

02001

Zero Speed Bit

02002

Forward/Reverse (1: Reverse Operation) Bit

02003

Fault Reset Input Bit

02004

Frequency Agree 1 Bit

02005

Inverter Ready Bit

02006

Warning Bit

02007

Fault Bit