Lowrance electronic HDS 8 Benutzerhandbuch

The one-piece bracket assembly includes two black plastic ratchets. The ratchets are used to 

align the transducer with the boat hull. Each ratchet has the letters A-E molded into it.

 

Hold the transducer assembly against the  

 

transom. Look at the transducer from the  

 

side.Try to adjust the transducer so its face  

 

is parallel to the ground. If it does, then the  

 

"A" position is correct.

Transom

  Slide the transducer in the  

 

bracket and temporarily  

 

slide the bolt through the  

 

transducer bracket, as  

 

shown in the image at  

 

right. 

   Insert the ratchets in the bracket with the  

 

letter "A" aligned with the dot stamped on the  

 

outside of the transducer bracket, as shown in  

 

the following series of diagrams.

Ratchet

Bracket

Align dot and 

letter "A".

If the transducer will not adjust with its face parallel to the ground, remove the transducer and 

ratchets from the bracket. Reinsert the ratchets into the bracket, this time with the letter “B” 

aligned with the dot stamped in the bracket. 

Reassemble the transducer and bracket and place it against the transom. Again, check to see if 

the transducer will adjust so its face is parallel with the ground. Repeat this process until the 

transducers face will adjust so that it is parallel with the ground.