Furuno B042-004 Benutzerhandbuch

3. INITIAL SETTINGS 

For dealer: When connecting the transducers which are not programmed, contact to 
PRODUCT SERVICE SECTION SERVICE CENTER, FURUNO HEAD OFFICE. For new 
transducer or other make of transducer see FURUNO information for further information. 
 
Note 1: If you are continuing from paragraph 3.1, go to step 2. 
Note 2: If you have already entered transducer settings and wait to reconfirm them turn on 

the power while pressing any key. 

Note 3: The transducers of 54 – 64 kHz, 112 – 122 kHz and 171 – 181 kHz cannot be 

connected to the FCV-1100L because of noise. (Available range: HIGH; 40 – 220 
kHz, LOW; 25 –220 kHz). 

 
1.  Turn on the power. 
2.  Press any key. 
3. Press ["] to select XDCR SELECT, and then press [+] or [-] to show the dialog below. 

   MANUAL

4.  Press [+] to select MANUAL, and then press [!] or ["] to close the dialog box. The 

display should now look something like the one below. 

 

  INSTALLATION   DEMO 

XDCR SELECT

:

MANUAL

[HIGH] 
CONNECTION

: NOT CONNECTED

FREQ

: ---kHz

[LOW] 
CONNECTION

: NOT CONNECTED

FREQ

: --- kHz

POWER REDUCTION : OFF

Select how to set XDCR type.

[-/+]: Change setting, Turn OFF to exit

5.  Do the following for both the high and low frequency transducers, or whichever 

transducer is installed. 

a) Press ["] to select CONNECTION of [HIGH] or [LOW], and then press [+] or [-] to open 

the dialog box. 

NOT CONNECTED  

b)  Use [+] or [-] to select CONNECTED, and then press [!] or ["] to close the dialog box. 

c) Press ["] to select FREQ, and press [+] or [-] to display the frequency setting dialog box. 

--- kHz