Broilmaster SS26P-1 Benutzerhandbuch

B101586-7-1012

Page 8

1. 

For Stationary Cart Assembly: Use the template on page 

23 to locate and pre-drill the three screw holes into wood or 

concrete for the cart base. If applicable, drill the 1 1/2” gas line 

access hole. DO NOT secure base with the screws at this time.  

For Mobile Cart Assembly: Flip plastic base and insert casters 

by inserting the pin provided with the casters in the proper hole. 

It is recommended that the two casters with brakes should be 

in the front of the base. See Figure 1.

2.  Place the base support brackets on the side panels. Slide the 

short flanges on the brackets between the top and side flanges 

of the side panels. See Figure 2. 

3.  Align the holes on the front and side panel assemblies and 

secure with six #10-24 x 1/2” Phillips screws and 10-24 Keps 

Nuts provided (3 on each side). Do not tighten these screws 

until all are installed. Use black screws for black carts and 

stainless steel screws for stainless steel carts. See Figures 2 

and 3.

4.  Secure the completed assembly to the base with four  

1/4-20 x 3/4” Phillips Truss screws. See Figure 4. Note: Plastic 

base comes with factory installed threaded inserts. Install all 

four screws before tightening.