Broilmaster SS26P-1 Benutzerhandbuch

B101586-7-1012

Page 9

5.  Attach Rear Brace to the Left and Right Side Assemblies with 

two 1/4-20 x 3/4” Phillips Truss Head screws and 1/4-20 Hex 

nuts. See Figure 5. Important: Make sure the brace goes in 

the cutout of the support bracket.

6.  Insert bushing in the front panel on the right for P and H  series 

and on the left for R and T series grills. Install rubber guard 

over cart cut out. See Figure 6.

Note:  Bushing is used to protect the ignitor wires from 

rubbing on the front panel when they are in place. 

 

Note: Ignitor wires must go through the bushing before grill 

head is fully installed.

7.  Secure the grill head to the cart using four 1/4-20 x 3/4” Hex 

Head Bolts and 1/4 x 5/8 Flat Washers.  See Figure 7. 

8.  Attach the Heat Shield to the Left and Right side assemblies 

with two 1/4-20 x 3/4 Phillips Truss Head screws and 1/4-20 

Hex nuts. Make sure shield is resting on the cutout provided 

in the side panels before tightening the screws and nuts. See 

Figures 8 and 9. Note: Grill head removed for clarity.