Combi 8100 Benutzerhandbuch

Connect low anchor connectors to vehicle lower
anchors.

- Position the lower anchor belt with the 

belt adjuster slide button facing away 
from the car seat. If the adjuster is not 
in that position, turn the belt and adjuster 
over. Check that lower anchor belt is flat,
not twisted.

- With hook-on connector opening facing down    , 

position the opening of the connector over the 
vehicle lower anchor. Push down    and then
pull out    on the connector to lock it onto the 
vehicle anchor (fig. f). You should hear a click.

- Pull on connector to be sure it is locked onto 

the anchor.

- Repeat for connector on opposite side.

Tighten lower anchor belt to secure the car seat. 

- Press down in center of car seat to depress 

the vehicle cushion and pull free end of lower 
anchor belt to tighten belt (fig. g).

2

3

1

1

2

3

Check recline of car seat. Line inside level 

indicator MUST be in green striped zone (fig. e).

If line is not in green striped zone, adjust recline 

position or place tightly rolled up towel, blanket 

or firm foam (pool noodle) under end of car seat 

contacting vehicle seat back (fig. h). 
If car seat can not be adjusted to locate 

the line in the green striped zone:

1.  Try a different seating position.

2. Do not use this car seat.

NOTE: Vehicle must be parked on horizontal 

surface and child in car seat when 

checking angle of car seat.

Check for secure installation. Gripping car seat at

top of armrest, pull car seat front to back and left 

to right to check for secure installation (fig. i). 

LATCH belt MUST stay tight.

- If LATCH belt does not stay tight or car seat 

can not be securely installed, try a different 

LATCH location or use the vehicle’s seat belt 

to secure the car seat.

Recheck recline of car seat. Adjust if necessary 
(see step 11).