Monessen Hearth VFCS20DPV Benutzerhandbuch

 

 1.  Turn ON/OFF switch to OFF position.
 2.  Turn control knob clockwise

to OFF position to completely shut off the heater.

 3.  If applicable: Turn off all electric power to the heater.

Hi/Lo Control 

Ignitor/Pilot Control

On/Off Switch

(Located on Side 

of Stove) 

 1.  STOP! Read the safety information label.
 2.  Make sure the manual shutoff valve is fully open.
 3.  This gas log set is equipped with an ignition device (piezo) which automatically lights the pilot. If piezo

ignitor does not light the pilot, refer to instructions for Match Lighting Instructions, page 23.

 4.  Turn gas control knob clockwise

to the OFF position, turn ON/OFF switch to OFF position.

 5.  Wait (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP!

Follow the instructions under What To Do If You Smell Gas, page 21.

 6.  From OFF position, turn the gas control knob counterclockwise

to IGN position. Push in

control knob for 5 seconds. NOTE: If you are running the heater for the first time, it may be 

 7.  With the control knob pushed in, push in and release the piezo ignitor button to light the pilot.
 8.  Continue pushing the control knob in for a further 10 seconds to prevent the flame detector from shutting

off the gas while the probe is warming up. Release the control knob.

 9.  Turn gas control knob counterclockwise

to the ON position.

10.  After the pilot has been lit for one minute, the burners can be turned on. Turn the ON/OFF switch to ON

position.

11.  If the gas logs will not operate, follow the instructions “To Turn Off Gas To Heater” below and call your

service technician or gas supplier.