Dixon 36 Benutzerhandbuch
50-
DIXON
LUBRICATION
Deck Outer Spindle
Lubricate using a grease gun, one zerk, each side 2-3
Lubricate using a grease gun, one zerk, each side 2-3
strokes.
Use only good quality bearing grease.
Use only good quality bearing grease.
Place the machine on a flat surface.
1.
Place a container under the engine where the
2.
hose from the oil drain valve exits.
Remove the dipstick and open the drain valve.
Remove the dipstick and open the drain valve.
3.
Allow the oil to run out into the container.
4.
Then close the oil drain valve.
5.
Replace the oil filter if necessary.
6.
Fill with new engine oil in accordance with
7.
Checking the Oil Level.
Start the engine. Run it for a few seconds. Stop
Start the engine. Run it for a few seconds. Stop
8.
and re-check the oil level.
IMPORTANT INFORMATION
Used engine oil is a health hazard and
Used engine oil is a health hazard and
must not be disposed of on the ground or
in nature; it should always be disposed
of at a workshop or appropriate disposal
location.
Avoid skin contact; wash with soap and
Avoid skin contact; wash with soap and
water in case of spills.
WARNING!
Engine oil can be very hot if it is
Engine oil can be very hot if it is
drained directly after stopping
the engine. Allow the engine to
cool somewhat first.
8011-733
Deck outer spindle
8011-730
Oil drain valve
Engine Oil
Changing the Engine Oil
The engine oil should be changed for the first time
Changing the Engine Oil
The engine oil should be changed for the first time
after 5-8 hours of operation. Thereafter, it should be
changed every 50 hours.