Snapper 421823BVE Benutzerhandbuch

 

DO NOT attempt any adjustments, maintenance, 
service or repairs with the engine running. STOP 
engine. STOP blade. Engage parking brake. Remove 
key. Remove spark plug wire from spark plug and 
secure away from plug. Engine and components are 
HOT. Avoid serious burns, allow all parts to cool 
before working on machine. Fuel Filler Cap and vent 
must be closed securely to prevent fuel spillage. 
 

4.3  REAR ENGINE RIDER DRIVE COMPONENTS 

 
IMPORTANT: If the Rear Engine Rider will be on its rear 
bumper for longer than two hours, remove the battery.  
Refer to Section “BATTERY REMOVAL”. 

 
5. 

Measure the distance between end of 

clutch/brake cable and bottom of housing. 

 

Measurement should be 3/4”.  See inset, Figure 
4.9. 

 

 

 

6. If measurement is not 3/4”, loosen the two jam-

nuts (shown in Figure 4.10) holding the clutch/brake 

cable to the chain case bracket.  

7. Adjust cable up or down using the jam-nuts to 

obtain a distance 3/4” between end of clutch/brake 

cable and bottom of housing.  See Figure 4.9. 

8. After adjustment is complete, securely tighten 

cable jam-nuts and retest wheel brake. 

 

 

1.  Inspect blade frequently for signs of excessive 

wear or damage. See Figure 4.11.