Snapper 421823BVE Benutzerhandbuch

 

must be closed securely to prevent fuel spillage. 
 

1.  Follow WARNING statement found on this page. 

2.  Check fuel level in tank.  If over 3/4 full, remove 

tank. Refer to Section “REMOVING FUEL TANK”. If 

3/4 or less, proceed to next step.  

3. Carefully stand Rear Engine Rider on rear 

bumper. 

4. Route new belt through engine belt guide up to 

engine pulley. See Figure 4.14. 

 

 

5.  Move transmission shift lever to the neutral (N) 

position. 

6. Rotate clutch yoke (clutch yoke shown in Figure 

4.10) out with your hand and work belt between drive 

disc and rubber driven disc.  

7.  To clear the primary chain case, move 

transmission shift lever to the #5 position. Route 

belt around drive disc and into drive pulley belt 

groove. See Figure 4.14. 

8.  Remove idler.  See Figure 4.15. 

9.  Route belt onto spindle pulley.  Make sure belt is 

inside spindle belt guide and idler belt guide. Route 

belt as shown in Figure 4.15.  

10. Reinstall idler removed in Step 8. The idler belt 

guide tab should be positioned in the hole located on 

idler arm.  Tighten idler pulley bolt securely. 

 
 
 
 
 
 

 

 

11. Adjust belt guide.  See Figure 4.16 for proper 

belt-to-belt guide clearances. 

12.  Reinstall mower drive belt cover.