Dixon 422 Benutzerhandbuch

 

Keep all connections clean and tight. Maintain the fluid 

in the battery at correct level.

 

 

The body may be washed with a mild detergent and 

waxed with any automotive type wax.

 

 

For adjustment or repair confer with authorized 

Dixon dealer service department. Adjustment or 

repair by other than authorized dealer voids 

warranty.

 

 

See your dealer for ordering spare parts or 
warranty service.

 

 

1. Attach stabilizer arms to mower deck with pins and 

clips-as shown on drawing.

 

2.  Attach the ½ “ dia. engaging rod with a rollpin 

through the engaging cam.

 

3.  Position the drive belt on pulleys.

 

4.Place mower deck under unit in approximate 

operating position with engaging rod through hole in 

the floor.

 

5. Connect drive belt to lower engine pulley, being 

certain that belt is inside of belt guides. Loosen belt 

keeper by  loosening the two rear engine mount 

bolts; this will allow belt to be placed on motor pulley. 

Retighten engine mount bolts.

 

6. Attach lift linkage to mower deck on the inside of the 

attaching lugs as shown on drawing with pins and 

clips. (4 places)

 

7. Attach stabilizer arms to pivot point on the inside of 

attaching bracket with pins and clips.

 

8. Place engaging handle on engaging rod and fasten 

with bolt and locknut.

 

9. Connect pan wire loom plug to plug on frame wire 

loom. Mower will not start unless this connection is made.

 

 

10. After installing pin clips, rotate pins so that open end of clip 

is down.