Technicolor - Thomson 510 Benutzerhandbuch
4 Troubleshooting
3EC 37891 AAAA TCZZA Ed. 01
43
How to perform a
hardware reset to
factory defaults
Proceed as follows:
Factory default service
settings
When the SpeedTouch™ leaves the factory and after every hardware reset to defaults,
the SpeedTouch™ features the following factory default settings:
the SpeedTouch™ features the following factory default settings:
•
Default IP configuration:
•
IP address: 10.0.0.138
•
Auto IP address
•
System password: not set
•
DHCP server: disabled
•
DNS server: disabled
•
Master firewall: enabled
•
Default Connection profile settings:
•
IEEE802.3D Transparent Bridging on VPI*VCI=8*35
•
IEEE802.3D Transparent Bridging on VPI*VCI=0*35
Step
Action
1
Make sure the SpeedTouch™ is powered off.
2
Press the power button once (shortly).
3
As soon as the Power/System LED is flashing green, press the power button
once more (shortly).
once more (shortly).
4
The Power/System LED stops flashing to become solid green. After six
seconds, it starts flashing green again. Press the power button once more
(shortly).
seconds, it starts flashing green again. Press the power button once more
(shortly).
5
All LEDs flash green once.
6
The SpeedTouch™ reboots and will come online with factory default settings.
Resetting the system to its factory defaults also involves deleting the configu-
ration profile settings. You may, therefore, need to reconfigure the system
using the SpeedTouch™ Setup wizard or by uploading the relevant configura-
tion file. See section
ration profile settings. You may, therefore, need to reconfigure the system
using the SpeedTouch™ Setup wizard or by uploading the relevant configura-
tion file. See section
for
more information.