Wasp WLS9500 Betriebsanweisung

4-8

Scan a bar code below to set the scan line width. 

This parameter sets the maximum time that decode processing continues during a scan attempt. It is programmable in 
0.1 second increments from 0.5 to 9.9 seconds. The default Laser On Time is 3.0 seconds.

To set a Laser On Time, scan the bar code below. Next, scan two numeric bar codes beginning on page 

C-1

 in 

 that correspond to the desired on time. Single digit numbers must have a leading zero. For 

example, to set an On Time of 0.5 seconds, scan the bar code below, then scan the “0” and “5” bar codes. If an error is 
made, or the selection needs to be changed, scan Cancel on page 

C-4

.