Enterasys csx400 Betriebsanweisung
Configuration: DDS Service
Local Management User’s Guide
2-29
In FR PtoMP, there is an option to statically enter the DLCIs in association with a Protocol
Manager, the physical port and MIB II, using the DLCI field in the Interface screen. If the DLCI is
not static, it will be deleted if the Frame Relay switch determines that the DLCI has been
eliminated. If the Frame Relay switch previously reported status on a DLCI, when it does not
report the status of the DLCI, the DLCI and its associated information is deleted from the
platform. Static entries are never deleted automatically. They must be deliberately deleted by the
user. To enter a DLCI, it is set to “Inactive” and saved, but to delete a DLCI, it must be accessed
and entered as “Invalid” and saved.
Manager, the physical port and MIB II, using the DLCI field in the Interface screen. If the DLCI is
not static, it will be deleted if the Frame Relay switch determines that the DLCI has been
eliminated. If the Frame Relay switch previously reported status on a DLCI, when it does not
report the status of the DLCI, the DLCI and its associated information is deleted from the
platform. Static entries are never deleted automatically. They must be deliberately deleted by the
user. To enter a DLCI, it is set to “Inactive” and saved, but to delete a DLCI, it must be accessed
and entered as “Invalid” and saved.
The WAN configuration for Frame Relay is complete. Communications between the HSIM or
CyberSWITCH and the service provider’s switch takes approximately one or two minutes to
complete. A status of Inactive displays on a DLCI per DLCI basis by default until both ends of the
DLCI are configured correctly. Once both end devices have negotiated link management with the
switches, and are configured correctly on a DLCI per DLCI basis, the status field displays Active.
CyberSWITCH and the service provider’s switch takes approximately one or two minutes to
complete. A status of Inactive displays on a DLCI per DLCI basis by default until both ends of the
DLCI are configured correctly. Once both end devices have negotiated link management with the
switches, and are configured correctly on a DLCI per DLCI basis, the status field displays Active.
Configuration: DDS Service
This section provides step-by-step instructions for connecting the HSIM or CyberSWITCH to a
Digital Data Service circuit in a PPP or Frame Relay environment. This example assumes the setup
similar to the one shown in
Digital Data Service circuit in a PPP or Frame Relay environment. This example assumes the setup
similar to the one shown in
using two CSX400s with HSIM or CyberSWITCH
modules installed.
Figure 2-13 WPIM-DDS Interface Configuration for PPP
Telco Cloud
2750_03
WPIM-T1/ DDS
in DDS mode
in DDS mode
WPIM-T1/ DDS
in DDS mode
in DDS mode
Host Platform
Site #1
Host Platform
Site #2