Enterasys csx400 Betriebsanweisung
Appendix A: WPIM-SY Configuration
A-6
Local Management User’s Guide
FRAME RELAY CONFIGURATION
This section provides instructions for connecting the WPIM-SY to a DDS (Digital Data System)
circuit in a Frame Relay environment. Refer back to
circuit in a Frame Relay environment. Refer back to
The line configuration information shown in
WPIM-SY Physical Configuration
Begin the WPIM-SY Frame Relay configuration by accessing the WAN Configuration screen
through Local Management. Proceed with the following steps:
through Local Management. Proceed with the following steps:
1.
Use the arrow keys to highlight the [WPIM] field at the bottom of the screen. Press the
SPACEBAR to select the WPIM being configured, then press ENTER.
SPACEBAR to select the WPIM being configured, then press ENTER.
2.
Use the arrow keys to highlight Mgr Type. Press the SPACEBAR to set the Mgr Type to
FR PtoMP (Frame Relay Point to Multipoint) or FR PtoP (Frame Relay Point to Point), then
press ENTER. These are the two settings for Frame Relay. Frame Relay Point to Point has one
Interface per DLCI assigned when DLCIs are created by the Service Provider. In Frame Relay
Point to Multipoint, there is one interface to multiple DLCI’S, and the DLCIs are dynamically
learned. Backup can only be run on FR PtoP, not FR PtoMP.
FR PtoMP (Frame Relay Point to Multipoint) or FR PtoP (Frame Relay Point to Point), then
press ENTER. These are the two settings for Frame Relay. Frame Relay Point to Point has one
Interface per DLCI assigned when DLCIs are created by the Service Provider. In Frame Relay
Point to Multipoint, there is one interface to multiple DLCI’S, and the DLCIs are dynamically
learned. Backup can only be run on FR PtoP, not FR PtoMP.
3.
Use the arrow keys to highlight SYNC PORT TYPE. Press the SPACEBAR to set the Sync
Port Type to V.35, RS422, RS232, or X.21.
Port Type to V.35, RS422, RS232, or X.21.
4.
Use the arrow keys to highlight FORCE CTS True. Press the SPACEBAR to set to NO.
5.
Use the arrow keys to highlight FORCE DSR True. Press the SPACEBAR to set to NO.
6.
Use the arrow keys to highlight FORCE RTS True. Press the SPACEBAR to set to ENABLE.
7.
Use the arrow keys to highlight FORCE DTR True. Press the SPACEBAR to set to
ENABLE.
ENABLE.
Table A-2
Telco Configuration Information
Configuration Information Required By User
Configuration Information Supplied By Service
Provider
Provider
Clock Source
Telco provided or no clock source
Circuit Speed
64K, V.35, RS-422, RS-232, etc.