Cisco SG300-10 Anleitung Für Quick Setup

Circuit Overloading—Adding the device to the power outlet must not 
overload that circuit.

To rack-mount the switch in any standard rack, attach the rack–mount 
brackets to the sides of the switch with the supplied hardware and secure 
the brackets tightly.

For stability, load the rack from the bottom to the top, with the 
heaviest devices on the bottom. A top-heavy rack is likely to 
be unstable and may tip over.

Only the 8-port models of the switch can be wall-mounted.

The switch should be mounted so that the ports face up or down. 

Do not mount the switch with the ports to the side.

There is a wall-mount kit packed with your switch. The dimensions for the 
mount kit are as follows:

Mount the managed switch to the wall by drilling two pilot holes 
3.7 inches (95 mm) apart, attaching the provided anchors and screws to 
the wall, then sliding the switch into position on the screws.

The switch should have a minimum of 5 inches (130 mm) of clearance on all 
sides.

Insecure mounting may damage the device or cause injury. 
Cisco is not responsible for damages incurred by insecure wall-
mounting.

1 8 mm/0.4 in

2 22.2 mm/0.9 in 3 6.8 mm/0.3 in

4 17.6 mm/0.7 in

196243