Microgem mg725 Betriebsanweisung
• YES: Firmware upgrade function enabled. If any firmware inside iPod, it starts
firmware update automatically right after you exit SETUP mode. After
updating iPod, it goes back to disabled state (NO) automatically.
• NO. : Firmware upgrade function disabled
8.5.6 VERSION MODE
VERSION MODE allows you to
check the firmware version on screen. To
remove the information, press ESC.
8.6 EXIT
SETUP
You can exit setup mode by selecting EXIT SETUP. By pressing SETUP key, you
can exit setup mode too.
9 FAQ
(Trouble
shooting)
Problem Possible
solution
CODEC NOT SUPPORTED
message appears on screen.
Check if a selected file is supported by the system.
Check your firmware version, and if new firmware is
available, please update.
DIVX DECRIPTION ERROR
Check if the movie file format is supported by the system.
NO MEDIA DETECTED
message appears
Check if the iPod or USB storage device is securely
connected to the MG725 connector.
Nothing appears on screen
Check if the A/V OUT cable is properly connected to TV or
receiver’s A/V input terminal.
Make sure they are securely connected.
Snowy picture (image is
unclear and snowy)
Check if the correct TV type (NTSC/PAL) is chosen.