Quantum DLT-V4 Betriebsanweisung
DLT-V4 Product Manual
4
Chapter 2
2
Installing the Internal
SCSI Tape Drive
This chapter contains step-by-step instructions for installing the internal
SCSI tape drive.
Equipment Required
2
All you need to install the DLT-V4 internal SCSI tape drive is a
PHILLIPS® screwdriver and adequate ESD protection.
SCSI Bus and Cable Requirements
2
The DLT-V4 SCSI interface tape drive incorporates a wide Ultra160 low-
voltage differential (LVD) small computer system interface (SCSI) bus,
but you can also attach it to a single-ended (SE) SCSI bus.
Make sure the SCSI host adapter or controller supports these
Make sure the SCSI host adapter or controller supports these
configurations. If you connect the tape drive to an SE bus, or if there are
SE devices attached to the same SCSI bus, the tape drive’s performance is
limited to the maximum data transfer speed and maximum cable lengths
of the SE bus (usually 40 MB/s). The DLT-V4 is not compatible with a high-
voltage differential (HVD) SCSI bus.