Quantum DLT-V4 Betriebsanweisung

Chapter 2 Installing the Internal SCSI Tape Drive

Unpacking the Internal SCSI Tape Drive

DLT-V4 Product Manual

Unpacking the Internal SCSI Tape Drive

Before you do anything else, unpack and inspect the tape drive for

shipping damage. If you notice any damage, report it both to the sales

representative and to the shipping company immediately.

If there is no damage to the tape drive, select a server or workstation to

host the tape drive, then move on to the following installation steps.

Setting the SCSI ID

All SCSI devices attached to the server or workstation that is to host the

tape drive must have a unique SCSI ID. Check the SCSI IDs on all other

devices on the selected server or workstation, including the SCSI host

adapter, and select an unused SCSI ID for the tape drive. The factory

default SCSI ID is 5. If the tape drive’s factory default SCSI ID is not being

used, you do not need to change the SCSI ID.

To set the SCSI ID:

Locate the SCSI ID jumpers on the rear panel of the tape drive, as

Note:

Save the packing materials in case you need to move or ship

the tape drive in the future. You must ship the tape drive in

the original (or equivalent) packing materials or you will

invalidate the warranty.

Note:

If you plan to attach the tape drive to a narrow (50-pin) SCSI

bus, you can only use IDs 0 through 7.