Quantum DLT-V4 Betriebsanweisung
Chapter 5 Installing the Tabletop SCSI Tape Drive
Installation Steps
DLT-V4 Product Manual
34
of the SE bus (usually 40 MB/s). The DLT-V4 is not compatible with a high-
voltage differential (HVD) SCSI bus.
If you attach the tape drive to a narrow (50-pin) SCSI bus, you must use a
If you attach the tape drive to a narrow (50-pin) SCSI bus, you must use a
customer-supplied 68-pin to 50-pin adapter that terminates the unused 18
pins. These adapters are sometimes labeled
high-byte termination
.
Make sure the total length of the SCSI bus does not exceed the ANSI SCSI
standard of 19 feet (6 meters) for an SE SCSI bus, 40 feet (12 meters) for an
LVD SCSI bus with multiple devices, or 82 feet (25 meters) for an LVD
SCSI bus with a single device.
Installation Steps
5
To install the tape drive, perform the following tasks in this order. Follow
the detailed instructions on the pages listed below.
Table 5 Installing the Tabletop
SCSI Tape Drive
SCSI Tape Drive
Step
Instruction
Page
1
Unpack and check the tape drive for shipping
damage.
2
Select a location near the server or workstation that
is to host the tape drive.
3
Download and install the current device driver (if
required) (see
).
4
Select a host server or workstation. Turn off power
and, if necessary, install an LVD/SE SCSI host
adapter in the server or workstation.
5
Set the SCSI ID.
6
Connect the SCSI cables.
7
Terminate the tape drive.