Quantum DLT-S4 Betriebsanweisung
Chapter 12 Installing the Tabletop Tape Drive
Connecting the Tape Drive to the Host Computer and Terminating the SCSI Bus
DLT-S4 Product Manual
103
Figure 39 Tabletop SCSI ID
Selector Switch
Selector Switch
Connecting the Tape Drive to the Host Computer and
Terminating the SCSI Bus
Terminating the SCSI Bus
12
You can connect the DLT-S4 tape drive to the host computer as a single
device, or as one of a maximum of two devices connected via SCSI cables
in a “daisy chain” configuration.
If you are connecting two devices to the SCSI bus, connect only the tape
If you are connecting two devices to the SCSI bus, connect only the tape
drive to the host computer at this time. Finish the installation procedure
and confirm that the host computer and tape drive are communicating
correctly (see
) before adding an additional
device (see
).
3
SCSI ID
selector
switch
selector
switch
Press here to decrease
SCSI ID
SCSI ID
Press here to increase
SCSI ID
SCSI ID