Quantum DLT-S4 Betriebsanweisung
Chapter 7 Fibre Channel Interface
Fibre Channel Speed and Topology
DLT-S4 Product Manual
59
Fibre Channel Speed and Topology
7
Although Fibre Channel DLT-S4 tape drives will auto-negotiate the speed
and topology, you may override the automatic selections by placing
jumpers on the Fibre Channel jumper block at the rear of the tape drive.
If you decide it is necessary to change the tape drive’s speed or topology,
If you decide it is necessary to change the tape drive’s speed or topology,
use your fingers to move the jumpers to the pattern corresponding to the
speed or topology you want. Using this jumper block is optional.
See:
•
for the Fibre Channel jumper block location
•
for the empty jumper block that you use to set the speed
and topology
•
for the various jumper setting combinations
Figure 19 Fibre Channel
Speed and Topology Jumper
Block
Speed and Topology Jumper
Block
Note:
The tape drive only checks the jumpers at a power cycle. To
change the speed or topology configurations after installation,
turn off the tape drive, move the jumpers as needed, and then
turn on the tape drive.