Quantum DLT-S4 Betriebsanweisung
Chapter 9 Installing an Internal SCSI Tape Drive
Equipment Required
DLT-S4 Product Manual
67
Equipment Required
9
You need the following items to install the tape drive in a system:
• Four (4) M3 x 8 mm long screws
• Screwdriver
• Jumpers (supplied)
• Internal Ultra320 SCSI cable, SPI-4 (or SPI-5) compatible
• Active Ultra320 SCSI terminator (if the SCSI cable is already
• Four (4) M3 x 8 mm long screws
• Screwdriver
• Jumpers (supplied)
• Internal Ultra320 SCSI cable, SPI-4 (or SPI-5) compatible
• Active Ultra320 SCSI terminator (if the SCSI cable is already
terminated at the end then you do not need this item)
Installation Steps
9
To install the tape drive, perform the following tasks in this order. Each
task is described in detail on the pages listed below.
Step No.
Step
Page
1
Unpack the tape drive.
2
Set the SCSI ID.
3
Secure the tape drive in the system.
4
Connect the cables and terminate the
SCSI bus.
5
Set TERMPWR.
6
Confirm the installation.
7
Add an additional device (optional).