Quantum tc2201e Installationsanweisungen

Quantum TC2201E Installation Instructions
Document 81-81449-01 A01
July 2005

10

Connecting the TC2201E

Figure 9  High Density 
SCSI Cables

During attachment of high density SCSI cables, please 

note the orientation (as shown in Figure 2-11) of the high 

density SCSI port connectors on the back panel of 

TC2201E. Failure to maintain appropriate orientation of 

the cables to the SCSI port connectors can result in damage 

to the SCSI port connectors on the TC2201E.

Do not plug HVD devices to an LVD/SE bus. Failure to 

heed this caution may result in severe damage to 

equipment.

 SCSI ports on the TC2201E are not hot-pluggable. Power 

off the TC2201E whenever connecting/disconnecting the 

SCSI cables. 

Any SCSI cables used with the TC2201E series product must meet SCSI 2 

standards and must be LVD rated (specifically low noise cabling). The cables 

should be rated at 24 Ohm impedance and should have a VHDCI 68pin .8mm 

D-shell/P-type to Standard 68pin SCSI D-shell connector at the end being 

attached to the TC2201E. The type of connector at the other end of the cable 

will be dependent on the device being connected. 

Please be advised that failure to comply with the 

minimum high density cable specifications can result in 

damage to the TC2201E or an operational failure of the 

product. 

 

 SE is not supported by SCSI-2 protocols. While it is possible to 

mix SE and LVD devices on the same bus, doing so may result 

in substantially decreased performance on the bus.