Quantum tc2201e Installationsanweisungen

Quantum TC2201E Installation Instructions
Document 81-81449-01 A01
July 2005

12

Connecting the TC2201E

Figure 11  TC2201E 
Ethernet port

0

The 3-pin connector on the back panel of the TC2201E provides a serial port 

that is compatible with RS-232 signaling levels. The TC2201E is designed to 

communicate with a terminal or any operating system utilizing a terminal 

emulator. The baud rate, data bits, stop bits, parity, and flow control of both 

the TC2201E and the host system must use the same settings. 

Figure 12  TC2201E Serial 
Port

0

Leave the TC2201E turned off until you have set up the serial port 

communications on your host computer, unless serial I/O was previously 

established and is currently running.
The TC2201E is designed to communicate with a terminal or any operating 

system utilizing a terminal emulator. For example, Windows 9x, NT 4.0, or 

Windows 2000 operating systems can use Hyper terminal. Be sure the baud 

rate, data bits, stop bits, parity, and flow control are set correctly.
To set up serial communications with the TC2201E:

Leave power to the TC2201E turned off until you have set up the serial 

port communications on your host terminal. 

Plug the serial cable into one of the host computer’s serial ports (COM1 or 

COM2), and then plug the other end of the serial cable into the TC2201E’s 

serial port

A 3-pin serial cable is included in the shipping container for 

the TC2201E.

.