Champion pp-28 Betriebsanweisung

COMPONENT REPLACEMENT

The wash tank heater is mounted on the side wall in the bottom of the tank. It maintains the
wash tank temperature at a minimum of 160˚F/70˚C. The heater is protected from a low water
condition by a surface mounted high limit switch.

1. Flip the power toggle switch to off.

2. Turn off the main incoming power.

3. Remove the lower left hand side panel.

4. Push the manual reset on the high limit.

Pull one lead from the high limit and check 
for continuity. Replace if open.

5. Apply a coating of heat sink compound,

P/N 110563, to the high limit before 
mounting to base.

1. Perform steps 1-5 from above.

2. Open the front door and remove the 

lower spray arms.

3. Remove the scrap screens amd pump

intake strainer. (See Fig 12 for 
element location in tank).

4. From the outside bottom of tank,

disconnect the heater wires and remove the
retaining nuts. (See Fig 13 for the 
rear view of the machine).

5. Remove the element from the inside of the tank.

6. Apply gasket to element and insert into tank.

7. Install retaining nuts.

8. Reconnect heater wires.

9. Replace panel.

10. Restore power to machine.

11. Check for leaks and proper operation.